PakCat catalogue record

Panjnad Abbasia Salinity control and Reclamation Project (Scrap-IV) Test Tubewells Report

Bibliographic details

Summary

In order to determine the parameters such as length of screen, specific drawdonw, gravel pack graduation, slot size and water quality etc for the tubewells to be installed in Unit-V of Scarp-VI, twelve test tubewells were installed. The installed capabity of three test tubewells is 1.5 cusesc each while the capacity of the remaining tubewells is 2.0 cusecs each. Different screen lengths have been used in the test tubewells. In case of test tubewells with installed capacity of 1.5 cusecs, the screen length varies from 100 feet to 140 feet while in case of test tubewells with installed capacity of 2.0 cusecs, the screen length varies from 160 feet to 240 feet. The length of punp housing casing installed on all test tubewells is 70 feet. Each test tubewells was run at 1,2,3, & 4 cusecs and their drawdonws for each discharge were recorded. Velocity meter was run in these test tubewells for 1,2&3 cusecs. Aqufier tests have been carried out on six tubewells. The development and design data of these test tubewells have been processed and cost comparison of differetn alternatives were made. The mechanical sieve analysis carried out on all the test tubewells have been used in preparing the gravel pack design to be used in project tubewells. The data of the velocity meter have been utilized to pin point such lengths of screen which have either not been developed properly or have been cased wrongly. The aquifer test data is under process and the value of co-efficients of trasmissivbility and storage are being calculated. As these values are not be used for determining the design parameters, the results of aquifer tests have not been incorporated in this draft reports. The following are the main recommendations derived from the analysis of data of the test tubewells:- 1. The length of not slotted tubewell casing (screen) to be installed in project tubewells should be calculated on the basis of an average entrance velocity of 0.1 foot per second. The width of slot size screen to be used should be 0.04". The approximate limits of gradation of gravel pack to be used in project tubewells is given on page 11. In order to design the pump head of tubewells and to calculate the length of the pump housing casing, the value of the drawdown shoudl be taken from figures 2 to 5.