PakCat catalogue record

Optimal Design of Subsurface Pipe Drainage System: Thesis for M.Sc. (Honours) in Agricultural Engineering

By Inamullah

Bibliographic details

Summary

For specified water table depth, there can be several combinations of drain depth, spacing and drain diameter that would control watertable to the specified depth but each with different cost. The combination of design variables with minimum cost is desirable from economic view point. The subsurface pipe drainage design was posed as a minimization of total cost problem that included objective function and constraints. The objective function considered was the minimization of total cost that included material and installation costs. Maintenance cost is considered to be sum fixed percentage of the total cost. In mathematical programming, constant does not effect the solution. Maintenance cost, therefore was not included in the minimization of total cost problem. Drain depth, spacing and diameter were constrained between minnimum and maximum values. Number of laterals, number of collectors, lateral diameter and collector diameter were considered integer variables. The optimization problem formulated, was non-linear mixed problem for which software was not available at the University of Agriculture, Faisalabad. Therefore, the problem was solved by evaluating the total cost at each feasible combination of design variables. Mardan SCARP was taken as a case study. Data on hydraulci conductivity, drainage coefficient, hydraulic gradient, pipe cost, installation cost, gravel cost and cost of manhole was used as input to the model. Since installation cost as a function of drain depth and drain diameter was not available in Pakistan, it was estimated based on the data from abroad. For hydraulic conductivity, K=1.0 m/day optimal values of spacing, depth, lateral length, diametr for lateral and collector, length of the collector were found to be 66.6, 1.598, 250, 0.092, 0.250 and 1000 m, respectively with minimum cost of Rs.28152/ha. Sensitivity analysis was conducted to see the effect of variations/changes in the input parametr on the optimal design and total cost. The order of sensitivity from higher to lower was of hydraulic conductivity (K), installation cost (ai), drainage coefficient (q), hydraulic gradient (i), pipe cost (ap), gravel cost (ag) and cost of manhole (aman) on the total cost. Based on the results of this study, shallow drains were found to be cheaper. Comparing the result of the optimal design with field data, the optimal design procedure was found to be good.