"Bed Form and Roughness of Alluvial Rivers" 'Source Title' Seminar on Mathematical Modeling of Alluvial Rivers 14-18 April, 1992 Kathmandu, Nepal
Bibliographic details
Summary
This paper describes about different types of bed forms and roughness of alluvial rivers. Also, it discusses about observed bed forms in laboratory and in the field. Under certain flow conditions with relatively low sediment transport rates, the sediment bed will deform into wave like forms with small slopes on their upstream faces, a sharp crest, ans steep downward faces. At higher velocities and depths the length of these forms may increase many folds still keeping the sharp crest. These forms move downstream at velocities that are small compared to the flow velocity. Sharp crested forms of this kind with wavelengths less than approximately 1 foot are called ripples, those with wavelengths longer than approximately 1 foot are called dunes. At some higher velocity, the ripples or dunes or both disappear and the bed becomes flat. At some still higher velocity, a wave of sinusoidal shape develops which usually move upstream and is accompanied by waves on the water surface. Sand waves of the latter type are known as anti-dunes are always accompanied by waves on the water surface that are called sand waves or surface waves. Surface waves are often unsteady, they usually move upstream slowly increase in amplitude until they become unstable, then break by curling over in the upstream direction and disappears only to form again and repeat the cycle. At even in higher velocities the form known as chutes and pool occurs. With ripples on the bed, the water surface may be plane or choppy. But with dunes, there is small depressions over the crest and rise over the trough. The flow is also characterised by large eddies or boils caused by the separation on the downstream of each dune.