PakCat catalogue record

Analysis of Pumping Well Near a Stream

By Bhatti, Sabir Ali

Bibliographic details

Summary

A pumping test was conducted to evaluate aquifer characteristics, the percentage of tube well discharge derived from the stream, and the effective distance to the stream simulated as a fully penetrating plane source of constant head. The formulae are applicable although a natural stream is seldom fully penetrating, because the distance from the stream to an aquivalent fully penetrating but imaginary plane source can be calculated. When pumping begins, the tubewell obtains most of its water from the immediate vicinity, but as the cone of influence expands, it receives a part of its water from the stream until a time is reached when it draws the entire amount of water from the stream. This will of course depend upon the aquifer characteristics, the tub well discharge, distance of the tube well from stream and the infiltration regimen of the stream. Different methods were used to fin the distance of stream equivalent to a fully penetrating plane source, the determination of coeficient of transmissibility and coefficient of storage, and, lastly, the amount of water that the tube well intercepts from the stream. The distance of the stream as flow. The data for later time were used assuming that canal leakage fully affected the pipe under analysis and it was not a time variable. As determination of T and S was based upon the inflection point on a time drawdown curve for the analysis, only pipes near the canals were chosen, where the recharge was predominat, and so the determination of inflection point and maximum dradown were easier. To find the maximum drawdown, the drawdown data of pieps near the canal, were replotted on uniform scale against 1/t and the maximum drawdown was determined from the tangent to the curve.