PakCat catalogue record

Hydrogeology of Hazro Area Pothwar

Bibliographic details

Summary

On the basis of the data collected during the course of investigations in the area it is concluded that:- The distribution of the aquifer material, i.e. the areal and vertical extent of the aquifers. The mode of deposition of the sediments, in the area, their texture and structure are typical of the valley fill depoists of small basins. The general declining resistivity measurements with depth in most the area can be attributed to the existance of fine textured formations like clay, shale or bedrock at variable depths. Trend of the field resistivity curves indicates absence of dense massive bedrock in the area except at resistivity probe site no.21,28 and 29 where the rising trend indicates the existance of some denser and massive material. Close examination of coloured cross-sections (fig: R-III) prepared on the basis of true resistivity values of the subsurface formations presents a general idea of the nature of alluvium, thickness of aquiclude and potential aqufier zones existing at variable depths, within the valley floor. The distribution and alignment of arenaceous water bearing material may also suggest the course of some old channels passing through the central part of the area. Sand and gravel depositso of Soan Formation and subrecent alluvial fill constitute the main groundwater reservoir. Groundwater so far has been developed in the area where depth-to-water is comparatively shallow, more potential exists in the area under-lain by the rolling sand and piedmont deposits. The specific yield of the sand and gravel deposits of Soan Formation, as computed from the pumping test at TW-47 (Qutha TS-4) is 0.000159 (mean of the values computed through different formulae and the mean lateral transmissibility is 0.034 cusecs/ft. or 22.200 gallons/day/ft. The values for the overlying alluvial sand and gravels should be a little higher. Tubewells with 0.5 to 1.0 cusec discharge can safely be installed in the area. The depth-to-water in area around shamsabad, as shown in figure 6 is within 10 feet from the land surface and the areas is threatened with the hazards of waterlogging. Near Surface, depth to water table in the vicinity of Shamsabad and Hazro demarcates a central plain zone affected by water-logging. The waterlogged zone is characterized by higher values of resistivity indicating good aquifers compring gravel and cobles existing at shallow depths. These aquifers overly low resistivity i.e the fine material formation, with rising slope towards G.T.Road and Kamra. Such type of sub-surface conditions may restrict some lateral movement of groundwater resulting in waterlogging of this central zone. This area is physiographically low-lying and covered by fine graline deposits i.e silt and clay which have very poor vertical permeability. Due to the above reasoons the drainage capacity of the soils is very low and afer the rains the water remains standing in the form of ephemeral lakes. This is mostly lost to evapotranspiration during the dry season. Chemical quality of groundwater in the area is fit for domestic and irrigation purposes. Almost all the water samples collectred from the open wells, tubewells and test holes contain less than 750 ppm. (parts per million) of dissolved solids except a few open wells near Mansar and Gondal which contain more than 750 ppm.