Injection Well Technology for Recharge of Groundwter in Bahalpur
Bibliographic details
Summary
In many parts of Bahawalpur Divsion, groundwater is being explited more than its natural recharge. Thus research on artificial recharge of groundwater was started in 1995 on the Compus of Islamia University Bahawalpur. An injection well was installed in the south on the Ahmedpur branch at a distance of 211 m from its bank where groundwater level was 3.6 m below the ground surface. The soil lithology exhibited loamy texture between 0 and 24-m depth, and sandy texture down wards. The injection well of 150 mm diameter sorrounded by 75-mm thick gravel envelop was lowered down to a depth of 25 meters; its strainer was placed between 16 and 24 m depth. A three was made against natural recharge from canal under no flow conditions, and that one for transient condition s, and that one for transient condition wad made against injection rate of 13 liters per minute (lpm) for 6 hours respectively. As there was no significant change in salinity status before and after operations of injection well, computer model was used only for the simulation of groundwater flow. Experiments were conducted for injection rates of 0.013, 030, and 0.090 m3/min. Though annulus around the injection well was sealed with cement concrete, even then then the high pressure created by the last injection rate developed craks in the cement block within short time. The cration of high pressure suggested that the annulus around the well should be tightly sealed. The computer simulations further suggested that if recharge were made in sandy layer, rise in pieozometric head would be decreased considerably. After its calibration, this computer model can further be used for various permutations of production or injection rate to help develop working criteria to pumping or storage in the groundwater reservoir within safe limits.