Groundwater Investigation for Water Supply Scheme Federal Capital Area Phase-I, (Sectors F-10, G-9, G-11, H-9, and Farash, Pandori and Tarlai Kalan Villages of National Park Area) Islamabad
Bibliographic details
Summary
Conclusions and Recommendations: After evaluation of the results of hydrogeologic reconnaissance, electrical resistivity survey, test drilling and aquifer test following conclusion and recommendations are given as under:- ; 1) Gravel formation, 5 to 70 feet thick, within the alluvium is the principal aquifer in sector G-9, H-9 and Pandori village of National Park Area. ; 2. Groundwater in the areas and sectors investigated exist under the water table conditions and depth to water ranges from 8 to 65 ft. below land surface depending upon togpography. ; 3. The chemical quality of groundwater is good. The water can safely be utilized for human consumption. ; 4. One test tubewell was installed in sector G-9 at test hole site CDA T/H-1. The tubewell was developed and tesed at three different discharges, i.e 180 gpm, 220 gpm and 250 gpm. This tubewell can be utilized after installing proper pumping equipment. Ar regards other potential sites in sector G-9 it is recommended that tubewell of appropirate design and capacity may be installed at resistivity probe site P-4/6 and P14. A tubewell of appropriate design may be installed at test hole site CDA T/H-7 in sector H-9 on the basis of lithologic data. Test holes may also be drilled at resistivity probe sites P-4 and P-9 in sector H-9 and these sites can be converted into tubewells, designed according to lithologic data of the test holes drilled. Test hole drilled at Pandori village (CDA T/H-3) can be converted into tubewell desinged according to lithologic data of the test hole. Resistivity probe site P-30 of Pandori village can also be exploited, for the development of groundwater by installing a tubewell. ; 5. Murree sandstone has been encountered as an aquifer in Farash, Tarlai Kalan villages in National Park Area and sector G-10, F-10 and G-11. This sandstone is in the range of low porosity and permeability due to its compactness and consolidation. This characteristic of sandstone encountered has reduced its yields, as is evident from the discharges observed during water sampling and data of recovery of water sampling. This suggest that tubewells of moderate discharge can be installed in these area. In Farash, test hole CDA T/H-2 has been drilled at resistivity probe site P-34 and sandstone has been encountered as an aquifer. Resistivity probe site P-30 and P-35 may also be attempted for exploitation of groundwater from sandstone aquifer. In Tarlai Kalan, in addition to resistivity probe site P-55 where test hole CDA T/H-4 has been drilled, probe site P-62 is recommended for exploitation of groundwater. In sector F-10 probe site 64 was selected for test drilling and test hole CDA T/H-6 was drilled. Sandstone aquifer was encountered in this test hole. As regards other prospective site in this sector, resistivity probe sites P.76 and P.79 are recommended in the order of preference. In the sector G-11 probe site P.8 was selected for test drilling and test hole CDA T/H-8 was drilled No. tubewell can be installed at this site as very limited thickness of sandstone aquifer has been encountered in the test hole drilled. ; 6. Electric logging/gamma ray logging should be carried out at each test hole after the drilling is over. ; 7. Tubewells should be designed on the basis of drilling data and installed with proper care and supervision. The tubewell when installed should be immediately and sufficiently developed with air compressors followed by development with turbine pump, mechanically driven at variable speed and discharge. Maximum pumping should be carried out during development of tubewells. ; 8. Capacity test should be run on the tubewells installed to assess the optimum capability of aquifer in terms of its safe yield.