PakCat catalogue record

Laboratory Scale Treatment of Tannery Wastewater 'Source Title' Science Technology and Development Volume Vol.14, no.2 (April-June 1995)

By Khurshid Ahmad

Bibliographic details

Summary

Environmentally, tanneries effluents are considered to be the worst polluters and difficult to treat. In Punjab, large number of tannery units are located in Kasur, Multan and Sialkot. The total effluent being generated from these units is estimated to be 18 cum/day having a BOD5 load of 11 tonnes/day. Laboratory investigations were carried out on the effluent of Shafiqque Tanneries in Kasur with the objective of suggesting a suitable methodology for its treatment. It was observed that the effluent discharge varied in quality and characteristics. The BOD5 COD and chromium contents of the waste varied from 950 to 1250 mg/l, 3800 to 4,700 mg/l and 24.0 to 32.0 mg/l respectively. On average the BOD/COD ratio fo the waste was observed to be 0.2 indicating a poor biodegradability. Simple treatment through plain sedimentation resulted in % removals for turbidity, BOD5, COD, SS and Cr as 49.78%, 29.0%, 50.0% 85.55% and 93.3% respectively. The settled effluent was then treate4d in a laboratory scale aerated lagoon having a detention time of 4 days. The removal achieved for SS, BOD5, and COD through this treatment were 94.2%, 75.7% and 72.43% respetive. In another set of experiments the effluent after plain sedimentation was subjected to chemical coagulation using an alum dose of 500 mg/l. The treatment resulted in the removal of turbidity from 84.2 to 94.5 per cent, SS from 92.8 to 97.0 per cent, BOD5 from 47.3 to 60.0 per cent and COD from 47.6 to 75.8%. After chemical treatment, the effluent was subjected to biological treatment in the same laboratory scale aerated lagoon having a detention time of four days. The treatment rendered an effluent with a BOD of 114 mg/l, SS 76.6 mg/l and COD 255 mg/l. Based on the laboratoyr scale investigations, treatment of tannery waste through plain sedimentation, chemical coagulation and biological oxidation in an aerated lagoon is recommended. Longer detention times in aerated lagoons may be considered to render the effluent conform with the EPA effluent quality standards.